Polished Glass, Marble & Shell Surfaces

On the Difference between Grinding and Polishing

Caution:  Portions of the following contain humor. If you have no sense of humor, discontinue reading now.

Well time has certainly passed since I started working with precast terrazzo. I could say that I had worked across five decades—which is true, since I started in 1979. But a more accurate accounting says this year is Number 33.

During this time, I have ground and polished more than my share of terrazzo. As with any basic process repeated endlessly over time, one comes to a deeper understanding of just what the heck one is doing. This is called insight (seeing the inner nature of the same old thing).

And so it goes with grinding and polishing, two critical steps that help distinguish precast terrazzo from its lately more popular first cousin, cast concrete; or more accurately, precast concrete.

The insightful difference between grinding and polishing, in essence, is this:  grinding is scratching a surface; and polishing is melting it.

Here’s a simple experiment you can try at home to help make your understanding of grinding more, um, concrete. First, buy a shiny new car (I like Lamborghinis). Next, put a bit of beach sand on the hood. Place a smooth brick on the sand, and rub briefly in a circular motion. Remove brick and sand, and observe. You will notice score marks on the surface, and dust. The grits of sand, being harder than the paint, have scratched furrows into the surface. Behind the scratching action of the grits, plumes of dust have come out of those furrows. This is grinding at its most basic. You want to grind wet to remove the dust, expose new surface, and keep your grinding medium clean and sharp.

Polishing terrazzo is entirely different. You are ready to polish when you have ground with successively finer grits, say 400 or 500 grit, and no scores are visible. The terrazzo should be bone-dry for best results. You can buy polishing powder or mix your own by combining tin oxide, powdered oxalic acid and flake shellac made from the bodies of the Asian Lac Beetle. (Wear a respirator.) Change the grinding head to a polishing pad or “mop.” Put some powder on the surface and mist it with a spray bottle. Spread this mud evenly over the surface with the polisher, moving in small tight circles. As it begins to dry out, bear down strongly on the polishing head to create heat of friction. Move slowly. This heat and pressure will superficially “melt” the surface, creating a vitreous surface. Mother of pearl shell, when polished in terrazzo, will light up and become incandescent from the heat—truly a sight to behold.

Caution is indicated, as it is possible to overpolish and “burn” a surface. You then have to regrind and repeat all the steps once more.

To recap, once again, grinding is scratching, and polishing is melting—completely different processes. These can both be done by hand, but are extremely tedious. I did this handwork my first three seasons before I even knew that I was doing terrazzo, or that equipment existed.

About these ads

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s